Full Flow Elbow is used for a pipeline which is required to turn through a 90° bend.

Full Flow Equal Tee piece is used for a branch line connected to a main line of the same size.

Full flow connector is used for connecting 2 pipes of the same size.

The Full Flow ®Flow Control is a fitting designed for restricting the flow in pipelines especially in undulating conditions where gravity causes an imbalance in operating pressures and this imbalance cannot be controlled by reducing pipe size alone.

Full Flow End Plugs are used for closing the end of a polypipe.

Full Flow Reducers are used where two pipes of different sizes are to be joined.

The Emjay® Insert Elbow is used for a pipeline which is required to turn through a 90° bend. It has two legs of the same size to join two lengths of polypipe of the same size. The use of Elbows is advised where the pipe needs to bend around a sharp corner which could kink the pipe if the Elbow were not used.

The Emjay® Insert Equal Tee Piece is used to join three lengths of polypipe of the same size. It is usually used to tee off a branch line connected to a main line of the same size.

The Emjay® Insert Connector is used for connecting two lengths of polypipe of the same size.  This fitting solves a problem that occurs when the polypipe is moved around and the shorter fittings pull out when the joint is bent.  It was made because of customer requests for such a fitting.

The Emjay® Flow Control is a fitting designed for restricting the flow in pipelines especially in undulating conditions where gravity causes an imbalance in operating pressures and this imbalance cannot be controlled by reducing pipe size alone.

The Emjay® Insert End Plug is used to close off the end of a polyethylene pipeline. A popular way to do this is to bend the end of pipe over and then use wire or some other method to tie the two pieces of pipe together thus closing off the end. 

The Emjay® Insert Reducer is used to join two lengths of polypipe of different size.